Application Guide

Foam It

  1. Fill the Foam Cannon: Fill the foam cannon reservoir with water.
  2. Add Concentrate: Add the desired amount of SiO2 Soap or Cancel the Salt to the water.
  3. Adjust Ratio: Adjust the ratio of concentrate to water to achieve your desired foam density.
  4. Apply Foam: Spray the foam onto the surface to be cleaned.
  5. Rinse: Rinse the surface with water to remove any residue.

**This applies to use of Foam Cannon with a regular hose or high pressure**

Motor Flushing

  1. Prepare the Inline Ratio Cup: Fill the cup with Cancel the Salt according to the desired ratio.
  2. Connect to Freshwater Source: Attach the cup to a freshwater source.
  3. Run the Equipment: Turn on the marine engine or other equipment and allow freshwater to flow through.
  4. Switch to Mixture: Switch the cup to the mixture setting and allow the solution to run through the equipment.
  5. Rinse: Rinse the equipment with freshwater to remove any residue.

Bucket Method

  1. Fill Bucket: Fill a bucket with clean water.
  2. Add Concentrate: Add the desired amount of SiO2 Soap or Cancel the Salt to the water.
  3. Agitate: Agitate the water with a spray hose to create a soapy solution.
  4. Wash: Use a wash mitt or scrub brush to apply the soapy solution to the surface to be cleaned.
  5. Rinse: Rinse the surface with clean water to remove any residue.